Canon EOS C700, Инструкция по эксплуатации

Страница: 56 / 250

Recording Video
56
IMPORTANT
• Observe the following precautions while an access indicator is illuminated in red. Failure to do so may result in
permanent data loss.
- Do not open the card slot cover of the card being accessed and do not remove the card.
- Do not remove the power source or turn off the camera.
• Be sure to save your recordings regularly (
A
158), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES NOTES
• If you record XF-AVC clips using the custom picture and metadata settings, those settings will be recorded
with the XF-AVC clip. For more details, refer to Custom Picture Settings (
A
131) and Using Metadata
(
A
118).
• If the camera switches to the other CFast card while recording video due to the relay recording function
(
A
52), the two parts (before/after the switch) will be recorded as separate clips.
• A single XF-AVC clip can be recorded continuously for up to 6 hours. At that point, a new clip will be created
automatically and recording will continue on a separate clip.
• You can use the [System Setup]
>
[Rec Operation Beep] setting to make the camera emit a sound
when you start/stop recording.
• If you set an assignable button to [Add
$
Mark] or [Add
%
Mark] (
A
127), you can press the button to add
an
$
mark or
%
mark to the last XF-AVC clip recorded.
• When you use a commercially available lens adapter and the image on the screen is inverted, you can use the
[System Setup]
>
[Scan Reverse Rec]
>
[Setting] setting to return the image to the correct
orientation.
Key lock: Locking the camera’s controls
To activate the key lock function, press and hold the
C
button. After the countdown that appears on the
control display ends, all the physical controls (buttons, switches, etc.) will be locked except for the
Q
,
REC and
C
buttons*. This is useful in preventing settings from being changed due to inadvertently pressing
the camera’s buttons and controls. Press and hold the
C
button again for about 3 seconds to reactivate the
controls.
Even when the camera’s controls are locked, you can operate the camera using Browser Remote (
A
166),
an optional RC-V100 Remote Controller connected to the camera (
A
123) or the controls on the lens. When
an optional OU-700 Remote Operation Unit is connected to the camera, you can select whether its controls
are locked along with those of the camera with the
[System Setup]
>
[
C
Button] setting.
* You can also choose to lock the REC buttons using the [System Setup]
>
[Key Lock] setting.