Canon EOS C300 Mark II, Инструкция по эксплуатации

Страница: 105 / 223

105
Adding Marks while Recording
Adding Marks while Recording
When recording, you can flag an important shot in a clip (only primary clips recorded on a CFast card) by adding
a “shot mark” (
!
). There are two types of shot marks, shot mark 1 (
"
) and shot mark 2 (
#
), and you can add
either or both types to a single clip. You can also add an OK mark (
$
) or check mark (
%
) to the entire clip to flag
clips you want to set apart. You can also perform this function remotely using Browser Remote on a connected
Wi-Fi device (
A
120, 122).
When the camera is in mode, you can add or delete shot marks (
A
158). You can also display an index
screen of all the shot marks (
A
157), allowing you to find a particular scene in a clip more quickly.
Adding Shot Marks while Recording
To add a shot mark to a clip while recording, you must first set in advance an assignable button to [Add Shot
Mark 1] or [Add Shot Mark 2].
1 Set an assignable button to [Add Shot Mark 1] or [Add Shot Mark 2] (
A
131).
• To add both shot marks, set one assignable button to [Add Shot Mark 1] and another assignable button to
[Add Shot Mark 2].
2 While you are recording, press the assignable button at the beginning of the shot you wish to mark.
• A message indicating the shot mark will appear and the selected shot mark will be added to the current
frame of the clip.
NOTES NOTES
• Up to 100 shot marks (
"
and
#
marks combined) can be added to a single clip.
• There may be up to a 0.5 second delay from when you press the button to when the camera adds the shot
mark.
• When you are using interval recording or frame recording mode, you cannot add shot marks to a clip.
• When a clip contains either shot mark,
!
will appear next to the clip’s thumbnail in the playback index screen.
Adding an
$
Mark or
%
Mark while Recording
While recording an important primary clip on a CFast card, you can add an OK mark (
$
) or check mark (
%
) to
the clip to flag it and set it apart. When the camera is in mode, you can display an index screen that
contains only clips with an
$
mark or only clips with a
%
mark (
A
148). Furthermore, you can use the
$
mark to protect important clips, as clips with an
$
mark cannot be deleted.
To add an
$
mark or
%
mark to a clip while recording, you must first set in advance an assignable button to
[Add
$
Mark] or [Add
%
Mark].
1 Set an assignable button to [Add
$
Mark] or [Add
%
Mark] (
A
131).
• To add both types of clip marks (to different clips), set one assignable button to [Add
$
Mark] and another
assignable button to [Add
%
Mark].
2 While you are recording, press the assignable button.
• A message indicating the clip mark will appear and the selected clip mark will be added to the clip.
NOTES NOTES
• A clip cannot have both an
$
mark and a
%
mark at the same time.
Operating modes: