Canon EOS C100 Mark II, Инструкция по эксплуатации

Страница: 24 / 214

Preparing the Power Supply
24
• Repeatedly charging and discharging the battery pack will eventually shorten its battery life. You can check the
battery life on the [Battery/Hour Meter] status screen (
A
179). Fully charging the battery pack and then
discharging it will give you a more accurate reading.
Attaching the Battery Pack
1 Set the
Q
switch to OFF.
2 Insert the battery pack all the way into the compartment as shown
in the illustration and press it gently toward the left until it clicks.
Removing the Battery Pack
1 Set the
Q
switch to OFF.
2 Press the BATTERY RELEASE button. While holding it down, slide
the battery pack toward the right and then pull it out.
Checking the Remaining Battery Charge
With battery packs compatible with Intelligent System, you can check the estimated remaining usage time of the
battery pack by looking at any recording/playback screen or the [Battery/Hour Meter] status screen (
A
179).
You can also check the approximate remaining battery charge on the battery pack itself.
Press the CHECK button on the battery pack. An indicator will light for
approximately 3 seconds and show the approximate remaining battery
charge.
0-25%
26-50%
51-75%
76-100%
NOTES
• The first time you use a battery pack, fully charge it and then use the camcorder until the battery pack is
completely exhausted. Doing so will ensure that the remaining recording time will be displayed accurately in
the various recording/playback screens.
0 100%
CHECK button
Battery charge indicator
COP
Y