Canon DADF-M1, Портативное руководство

Страница: 41 / 70

Chapter 2
2-7
F-2-14
3) Loosen the mounting screw [1], and remove the
screw [2] from the positioning hole, and fit it and
temporarily tighten it in the adjusting angular hole [3].
- if A > 1 mm, move the volume unit [6] to the
front.
- if B > 1 mm, move the volume unit [6] to the rear.
F-2-15
4) Move the original width volume unit [4] to the front
or the rear to make adjustments.
5) Tighten the screw [1] that has been tentatively
tightened and the screw [3] that has been fitted in the
adjusting angular hole.
6) When done, mount back the cover.
7) Make a copy of the Test Chart once again, and see
that the image is as indicated.
2.1.11 Leading Edge
Registration
0003-2362
1) Obtain the Text Chart.
If the Text Chart is not available, make one using A4
or LTR paper as follows:
F-2-16
2) Place the Text Chart in the original tray, and make
a copy of it at a 100% reproduction ratio.
3) Check to see that dimension A of the Test Chart and
the image obtained in step 2) are as indicated:
A </= 1 mm
B </= 1 mm
If not, go to step 4).
F-2-17
4) Start service mode as follows: press the User Mode
key, press the 2 and 8 keys at the same time, and press
the User Mode key once again.
[1] [2]
[1] [2] [3] [4]
Right angle
10mm
10mm
10mm
10mm
A
B