6 Appendix
Connection/Installation Checklist
50
Connection/Installation Checklist
Use the following checklist to verify correct operation after connecting/installing the system. Pay attention to the fact
that the items that can be checked before and after the installation are not the same.
Check item
Before
installation*
After
installation
Connections
Bolts are not loose (tightened to the correct torque).
▢
—
Cables are connected to the correct terminal/connector.
▢
—
Cables/connectors are firmly plugged all the way in.
▢
—
Cables/safety wires do not obstruct the operation of moving parts.
▢
—
The camera and lens are attached correctly and straight onto the camera
mounting bracket/lens supporter.
▢
—
There is enough available recording space on the card inserted in the camera.
▢
—
For installation in underslung position, the main capture camera and wide
view camera are installed in the correct orientation.
▢
—
The eyepiece camera is correctly set up according to the manufacturer’s
instructions and its focus is correctly adjusted.
▢
—
The lens’s zoom position is set to the wide-angle end before turning on the
camera head.
▢
▢
All the necessary safety/drop-prevention measures are installed.
—
▢
The rain cover openings are closed tightly (water leak prevention).
—
▢
The camera head is securely mounted on a stable location.
—
▢
The camera head is correctly connected to a network and power supply at
the shooting location.
—
▢
The power cable’s connector is firmly plugged into the DC IN 24V terminal.
—
▢
Web setup tool
The password and network settings were correctly configured after turning
on the camera head.
▢
▢
Connected devices are correctly registered.
▢
▢
Underslung mode is turned on/off according to the installation position.
▢
▢
The camera head, lens and zoom unit are operating unobstructed.
▢
—
Motion range limits are correctly set (e.g., the camera head does not hit a
wall with a slow operation speed, etc.)
—
▢
The camera and lens are correctly configured (physical switches and controls,
menu settings).
▢
—
Connected devices can be correctly turned on/off after performing the
homing procedure.
▢
▢
The IP controller is set to READY status.
▢
▢
* When using the optional rain cover, before attaching the rain cover.