Canon Colorado 1630, Руководство по эксплуатации

Страница: 358 / 388

Wrinkling media
Introduction
Solve media touches or print quality artefacts caused by the wrinkling of media in the transport
direction. When you are using a weaker media such as textile or canvas which is not fed in the
printer correctly or you are using a media type that is humid-sensitive, the media can start to
wrinkle on the platen in the transport direction. Follow the procedure below. You can stop at any
time in the procedure when the problem is solved.
Procedure
1.
When you see the wrinkling of media in the first meters of the print (incident based, after period
of inactivity):
1.
The wrinkling is caused by humidity or moisture. Enable the [Moist sensitivity] setting in the
RIP.
Change the media settings on page 67
.
2.
When you see the wrinkling of media in the first meters of the print (structurally):
1.
Set the [Print gap] setting in the RIP to [High].
Change the media settings on page 67
.
2. Increase the [Vacuum power] settings in the RIP. Increase with steps of 10%. For each step
you increase and have changed the setting: reload the media before you continue printing.
Observe the media movement on the platen first, before you increase the vacuum power
again.
Change the media settings on page 67
.
3. When you have set the [Vacuum power] setting correctly, set the [Print gap] setting in the RIP
back to [Medium].
Change the media settings on page 67 .
4. Perform media calibration. Calibrate the media on page 113 .
3. When you see the wrinkling of media after 1 to 3 meters:
1. Load the media roll on position 1. Load a media roll (position 1) on page 82 .
2. Feed the media manually.
3.
Manually cut the leading edge of the media.
4.
Use a different media type.
Wrinkling media
358 Chapter 9 - Troubleshooting and support