Canon CN20x50 Series, Руководство по эксплуатации

Страница: 19 / 32

E12
Before using shuttle-shot function, the shuttle function must be assigned to the VTR, RET, or AUX
switch of the drive unit, or the AUX1 or AUX2 switch on the zoom demand. This manual describes the
"Shtl" function assigned to the VTR switch. For details, refer to "5-6 SWITCH OPERATIONS".
5-1-5. Shuttle-Shot Function
This function allows you to switch between the current zoom position and the preset zoom position at the
maximum speed.
5-1-6. Speed Preset
This function allows you to call the preset zoom speed any time you zoom. Assign the "Sped" function
to the VTR, RET, or AUX switch of the drive unit, or AUX1 or AUX2 switch on the zoom demand. This
manual describes the "Sped" function assigned to the VTR switch.
1. Storing the zoom speed and direction
Operate the zoom rocker seesaw to determine the zoom
speed and direction (toward telephoto angle or widest angle)
which you want to store, and press the MEMO switch while
holding this position.
The stored zoom speed is applied to the "Framing
Preset".
The operation with the "Shtl" switch is given the priority over that with the zoom rocker seesaw. The operation
with the zoom rocker seesaw is disabled while the "Shtl" switch is pressed.
Current zoom position Shuttle memory position Previous zoom position
The "Shtl"
switch is
held down.
The "Shtl"
switch is
released.
Max
speed
Max
speed
Setting the shuttle memory position
Zoom to the position that you want to store. Keeping this
position, press the "Shtl" switch while holding down the
MEMO switch.
The "position" you stored here is different from the one
you set in "Framing Preset" mentioned later. The stored
position set here is retained even after the power is
turned off.
5 OPERATION
"Sped" Switch
Zoom Rocker Seesaw
MEMO Switch
"Shtl" Switch
Zoom Rocker Seesaw
MEMO Switch