Canon C200B, Инструкция по эксплуатации

Страница: 108 / 236

Adding Marks to Recordings
108
Adding Marks to Recordings
While recording XF-AVC clips, you can flag an important shot by adding a “shot mark” (
!
). After recording, you
can also add an OK mark (
$
) or check mark (
%
) to the entire clip to flag clips you want to set apart. You can
also perform this function remotely using Browser Remote on a connected Wi-Fi device (
A
170).
When the camera is in mode, you can add or delete shot marks (
A
147).
Adding a Shot Mark while Recording
To add a shot mark to a clip while recording, you must first set an assignable button to [Add Shot Mark].
1 Set an assignable button to [Add Shot Mark] (
A
125).
2 While you are recording, press the assignable button at the beginning of the shot you wish to mark.
• A message indicating the shot mark will appear and the selected shot mark will be added to the current
frame of the clip.
NOTES NOTES
• Up to 100 shot marks can be added to a single clip.
• There may be up to a 0.5 second delay from when you press the button to when the camera adds the shot
mark.
• When a clip contains a shot mark,
!
will appear next to the clip’s thumbnail in the playback index screen.
• Shot marks cannot be added in the following cases:
- During pre-recording mode before pressing the REC button to record.
- During interval recording or frame recording mode.
Adding an
$
Mark or
%
Mark after Recording
After recording an XF-AVC clip, you can add an OK mark (
$
) or check mark (
%
) to the clip to flag it and set it
apart. Furthermore, you can use the
$
mark to protect important clips, as clips with an
$
mark cannot be
deleted.
To add an
$
mark or
%
mark, you must first set in advance an assignable button to [Add
$
Mark] or [Add
%
Mark].
1 Set an assignable button to [Add
$
Mark] or [Add
%
Mark] (
A
125).
• To add both types of clip marks (to different clips), set one assignable button to [Add
$
Mark] and another
assignable button to [Add
%
Mark].
2 After recording, press the assignable button.
• A message indicating the clip mark will appear and the selected clip mark will be added to the clip just
recorded.
NOTES NOTES
• A clip cannot have both an
$
mark and a
%
mark at the same time.
Operating modes: