44
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure you have
made a correct connection to the projector audio input. See
for how the audio
input is connected.
Muting the sound
To temporarily turn off the sound, press
MUTE
on the remote control,
or:
1.
Press
MENU
and then press / until the
SYSTEM SETUP:
Advanced
menu is highlighted.
2.
Press to highlight
Audio Settings
and press
OK/IMAGE
. The
Audio Settings
page is displayed.
3.
Highlight
Mute
and press / to select
On
.
Adjusting the sound level
To adjust the sound level, press
VOL
+/- on the remote control, or:
1.
Repeat steps 1-2 above.
2.
Press to highlight
Volume
and press / to select a desired sound level.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do
not affect the projection settings, operation, or performance.
•
Menu Display Time
in the
SYSTEM SETUP: Advanced
>
Menu Settings
menu sets the length of
time the OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments. Use / to select a suitable time frame.
•
Menu Position
in the
SYSTEM SETUP: Advanced
>
Menu Settings
menu sets the OSD position
in five locations. Use / to select a preferred position.
•
Language
in the
SYSTEM SETUP: Basic
menu sets your familiar language for the OSD menus.
for details.
•
Splash Screen
in the
SYSTEM SETUP: Basic
menu sets a preferred logo screen to be displayed
during projector start-up. Use / to select a screen.
Shutting down the projector
1.
Press
POWER
and a confirmation message displays
prompting you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER
a second time. The
POWER indicator light
flashes orange, the projection lamp shuts down, and the fans will
continue to run for approximately 90 seconds to cool down the
projector.
3.
Once the cooling process finishes, the
POWER indicator light
is a steady orange and fans stop.
4.
Disconnect the power cord from the wall socket if the projector
will not be used in an extended period of time.
•
To protect the lamp, we suggest you not to operate the
projector during the cooling process.
•
To shorten the cooling time, you can also activate the Quick Cooling function. See
for details.
•
Do not unplug the power cord before the projector shutdown sequence is complete or during
the 90-second cooling down process.
2
1
I
I
I
I
