7
133349PDF
KP395/
- mech
KP396/
- DI2
1.1 N-m, 10 In-Lbs
Loctite 242 (blue)
KF115/
5 N-m,
44 In-Lbs
KP397/
28.6 mm
Carbon gel
SEAT POST
Use a high-quality carbon gel to install and maintain
the seat post. Cannondale kit KF115/ is a small
quantity, enough for two or three applications.
1. Clean the inside of the seat tube. Wipe it out
with a dry clean towel.
2. Apply a generous amount carbon gel to the
inside of the clean seat tube and to the seat
post. A small nylon brush works well for
spreading inside the seat tube.
3. Apply small amount of bicycle bearing grease to
the area under the binder on the seat tube and
reinstall the seat binder.
4. Insert the seat post, set saddle height, and
tighten the binder bolt to the specified torque.
REAR DERAILLEUR HANGER
To replace:
Remove the mounting screws and remove the old
hanger from the dropout. Clean the area around
the dropout and inspect the frame carefully for any
cracks or damage. If you find damage have the
frame inspected by your Cannondale Dealer .
If the dropout is un-damaged, apply a light film
of bike grease to both sides of the dropout. This
will help minimize any noise or “creaking” that
might result from very slight movement between
the dropout and hanger during movement of the
derailleur.
Slide the new hanger
KP395/ or KP396/ onto the
dropout. Apply Loctite to the screw threads and
tighten to the specified torque.
NOTICE
Do not use a derailleur hanger alignment tool.
If bending adjustment is necessary, remove the
hanger from the frame first!
Seat Binder
light grease
