Cannon TE-3000, Инструкция по эксплуатации

Страница: 11 / 46

7
CANNON
® TE-3000 Thermoelectric Constant Temperature Bath
Version 1.1c — May, 2005;
CANNON
® Instrument Company
2139 High Tech Road • State College, PA 16803 • USA
If the rear platform is not yet attached to the bath unit, you should attach
it using the two 6-32 screws provided. The tabs which will hold the
overflow jar in place should be facing upward.
Procedure
1. After the platform is securely in place, attach the 11" tubing to the
bath intake at the top rear of the bath unit by pushing the tubing
firmly over the intake nozzle. Then attach the other end of the tube to
the top of the Reciprocating Pump (next to the electric connector
cable) in the same way.
2. Remove the plastic nipple adaptor from the opposite end of the
Reciprocating Pump and insert the pump end into the small hole on
the Overflow Platform so the pump rests on the platform.
3. Reattach the nipple adaptor removed in Step 2 (this holds the unit in
place).
4. Attach the electric connector cable from the Reciprocating Pump to
the receptacle marked
PUMP
on the Control Unit. To connect the
cable, make sure to align it correctly with the Bath Unit female
connector (tab upwards), then push until the cable connection
“clicks” into place.
5. Attach one end of the 6" tube to the bottom connection on the
Reciprocating Pump.
6. Attach the 3" tube to the bath
unit overflow outlet located
above the Overflow Platform.
Place the Overflow Jar on the
platform, inserting the other
end of the 3" tube through the
lid of the jar.
7. Attach the other end of the 6"
tube to the connector on the
underside of the Overflow Jar.
Make sure that all connections
are secure.
Figure 4:
Positioning the overflow jar