© 2020
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
23
INSTALLING ThE REAR MOuNT ROD hOLDER
INSTALLING ThE REAR MOuNT ROD hOLDER
1
#20 X 1
Item(s) needed:
a. To secure the Rod Holder(s) on the Downrigger
Assembly, take one of the Soft Grip Knobs (Item
#20) and one Spring Release (Item #22). Place
one spring on the end of each Soft Grip Knob.
b. If the downrigger came with one Rod Holder,
determine which side of the downrigger to install
the Rod Holder on based on how your downrigger
is mounted and how it will be used. Once the
location of the Rod Holder is determined, take
the Dual Axis Rod Holder Arm (Item #26) and
turn it so that the short end of the elbow will be
placed against the Downrigger Assembly. The face
of the Dual Axis Rod Holder Arm that is installed
on the downrigger contains keyed teeth which are
matched on the Dual Axis Rod Holder Arm. These
keyed teeth will help to hold the position of the
knob and help to hold it in place when the position
of the holder is changed during use. Secure the
Dual Axis Rod Holder Arm with the Soft Grip Knob.
#22 x 1
#26 x 1
The Cannon Magnum and Cannon Magnum TS downriggers come with one Rear Mount Rod Holders. The Rod Holder incorporates a
two-piece locking tooth design. This allows independent adjustment
of the Rod Holder along two axes, which can be easily adjusted every
15° of rotation. The symmetrical design will allow mounting of the
Rod Holder on either side of the downrigger or two Rod Holders at
the same time. The spring along the shaft of the Soft Grip Knob
allows the knob to be loosened and the Rod Holder to be indexed
without fully disassembling it. To install, follow the steps below.
NOTICE:
The Rod Holder assembly is not covered under
warranty when used with tackle above 30 lbs. Equipment
placed in the Rod Holders and the loss thereof is the
responsibility of the user and is in no way warranted by
Johnson Outdoors, Inc. Mounting must be in accordance
with the instructions to comply with the product warranty.
CAuTION
The Rod Holder is intended for use of up to 30lb test line only and is not recommended for use with any tackle IGFA (International
Game Fish Association) rated higher than 30lb. A safety strap (not included) is recommended for all applications. The Rod Holder
should not be used as a handle or a rest point.
1a
1b
1b
1a
Soft Grip Knob
Soft Grip Knob
Soft Grip Knob
Soft Grip Knob
Spring Release
Spring Release
Spring Release
Spring Release
Spool Side
Spool Side
Motor Side
Motor Side
Spool Side
Spool Side
Motor Side
Motor Side
Soft Grip
Soft Grip
Knob
Knob
Soft Grip
Soft Grip
Knob
Knob
Dual Axis
Dual Axis
Rod Holder
Rod Holder
Arm
Arm
Dual Axis Rod
Dual Axis Rod
Holder Arm
Holder Arm
