Cannon Fitzroy FITZIB-PDEX series, Инструкция по эксплуатации

Страница: 15 / 24

LOG INSTALLATION
Refer FIG 21 .
2. Carefully unpack the log set. Logs are numbered
as follows:
#1 - Left front log
#2 - Left back log
#3 - Right front log
#4 - Right back log
Position the four individually numbered logs in the
following order on the burner bed as shown in
FIG 22-25 . The locating pins on burner bed must
engage with corresponding holes in the individual logs.
a) Place log #1 into the 2 front left pins on the burner
bed, ensuring that the charring faces the front.
Refer FIG 22 .
b) Place log #2 onto the 2 left back pins. Refer FIG 23 .
c) Place log #3 on single right front pin, ensure fork
locates over log #2. Refer FIG 24 .
d) Place log #4 on single right back pin, ensure left side
of log rests on depression in #3 log. Refer FIG 25 .
3 Refitt the inner glass, making sure not to over
tighten the screws.
4. Reconnect switch loom to the fascia switch set.
5. Refit the front fascia.
GAS CONNECTION
FIG 22 FIG 23
FIG 25 FIG 24
1. Push the gas inlet access plate into the heater cabinet
and slide the heater into the fireplace ensuring that the
gas inlet pipe is fed through the hole located at the rear
right hand side of the heater at the bottom.
Refer
FIG 26 .
2. With heater in position, flanges should be hard against
masonry. Secure case flanges to the masonry.
Screw or bolt the flange through the slots provided.
3. Connect the gas supply pipe to the copper compres-
sion fitting provided (we recommend using a basin
wrench). Push the gas inlet plate down to its original
position and seal with an appropriate easily remov-
able material. Do not seal with a silicone sealant as the
heater must be easily removable. Sealing is important
as it prevents any leakage of flue products into the
room. Test all connections for gas leaks.
4. Heater MUST NOT be connected using a flexible hose.
Burner In Base
Of Burner Chamber
FIG 21
Gas Inlet
Solid Copper Pipe
To Be Used Only
Gas Connection
½ Inch Compression
FIG 26
Same for Canterbury and Fitzroy
FIG 27
Same dimensions for Canterbury and Fitzroy
82 mm
41 mm
1. The burner is contained within the burner chamber.
Cannon Power Flue | 15
Note: The appliance must be secured at the front to a
a vertical face. Where this is difficult due to building
inaccuracies, limited non-combustible packing may be
used to obtain a suitable veritcal surface. Method of
fixing to finished wall surface (plater/masonry/brick)
suitable fixtures which are able to be easily removed
must be used.