Cannon 90cm Free Standing Gas Cooker C90DPX, Инструкция по установке и эксплуатации

Страница: 5 / 20

5
GB
Gas connection u sing a f le x i b le r ubb er h ose
Make sure that the hose complies with current
national legislation. The internal diameter of the hose
must measure: 8 mm for liquid gas supply; 13 mm for
methane gas supply.
Once the connection has been performed, make sure
that the hose:
• Does not come into contact with any parts that
reach temperatures of over 50°C.
• Is not subject to any pulling or twisting forces and
that it is not kinked or bent.
• Does not come into contact with blades, sharp
corners or moving parts and that it is not
compressed.
• Is easy to inspect along its whole length so that its
condition may be checked.
• Is shorter than 1500 mm.
• Fits firmly into place at both ends, where it will be
fixed using clamps that comply with current
regulations.
If one or more of these conditions is not fulfilled or
if the cooker must be installed according to the
conditions listed for class 2 - subclass 1 appliances
(installed between two cupboards), the flexible steel
hose must be used instead (see below).
C onnecting a f le x i b le j ointless stainless steel
p i p e to a t h rea d e d attac hm ent
Make sure that the hose and gaskets comply with
current national legislation.
To begin using the hose, remove the hose holder on
the appliance (the gas supply inlet on the appliance
is a cylindrical threaded 1/2 gas male attachment).
Perform the connection in such a way that the hose
length does not exceed a maximum of 2 metres,
making sure that the hose is not compressed and
does not come into contact with moving parts.
Ch ec k ing t h e tig h tness o f t h e connection
When the installation process is complete, check the
hose fittings for leaks using a soapy solution. Never
use a flame.
Ad a p ting to d i ff erent t yp es o f gas
It is possible to adapt the appliance to a type of gas
other than the default type (this is indicated on the
rating label on the cover).
Ad a p ting t h e h o b
Replacing the nozzles for the hob burners:
1. Remove the hob grids and slide the burners off
their seats.
2. Unscrew the nozzles using a
7 mm socket spanner ( see
figure ), and replace them with
nozzles suited to the new type of
gas ( see Burner and nozzle
specifications table ).
3. Replace all the components
by following the above
instructions in reverse.
Ad j usting the hob burners’ minimum setting:
1. Turn the tap to the minimum position.
2. Remove the knob and ad j ust the regulatory
screw, which is positioned inside or next to the tap
pin, until the flame is small but steady.
I f the appliance is connected to a li q uid gas
supply, the regulatory screw must be fastened as
tightly as possible:
3. While the burner is alight, q uickly change the position
of the knob from minimum to maximum and vice versa
several times, checking that the flame is not
extinguished.
The hob burners do not re q uire primary air ad j ustment.
After ad j usting the appliance so it may be used with a
different type of gas, replace the old rating label with a
new one that corresponds to the new type of gas (these
labels are available from Authorised Technical Assistance
Centres).
Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to “regulators for channelled gas”.