Cannon Tools NEILSEN CT4887, Инструкция по эксплуатации

Страница: 4 / 9

SPECIFICATIONS
Working pressure: 72-130Psi
Dimensions: 460 x 140 x 140mm
Maximum joint diameter 120mm
The CV boot installation tool is to be used solely for the stretching of flexible CV boots onto
drive-shaft assemblies of automotive vehicles.
SAFETY FIRST
Read the operating and safety instructions. Follow them carefully. Maximum safe operating
pressure 130 psi. Air lines are dangerous – use them correctly.Keep hands away from moving
parts. Never operate the CV boot installation tool near the face or body. Only use this tool to fit
CV boots. If air line pressure exceeds 130 psi, fit a regulator. Disconnect the CV boot
installation tool from the air supply after use.
PUTTING INTO SERVICE
Before use, check cap-retaining screws are secure. If the CV boot installation tool is dropped,
check for cracked components. Check air line pressure before connecting the Boot gun. The
CV boot installation tool should be used only by people trained in the use of pneumatically
operated tools.
ASSEMBLY / DISMANTLING
No assembly or dismantling is required. The air adaptor may be exchanged if necessary.
The body is threaded to accept 1/4 inch BSP connector.
AIR SUPPLY
To prevent explosion: Use only clean, dry, regulated, compressed air to power this tool. Do not
use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source
for this tool.