02-406 (Issue 1) 01/03
MINX MIXER - OPERATING INSTRUCTIONS
- 6 -
OPERATING INSTRUCTIONS
BACK PANEL
11.
Input Selector (Mic/Line)
When pushed-in, as indicated by orange iris, pads input to accept line level signals.
12.
Control Line Input (Cue)
Accepts line level signals for monitoring by presenter or engineer's headphones
(see 4). Connection may be by 3 pin XLR type connector or bare wires as in
temporary 'phone circuits.
13.
Mixer Output (Output)
Normally line level output (but see 14) XLR connector has low source impedance
for driving good quality music circuits, bare wire terminals have 600 ohm source
impedance for (e.g.) temporary 'phone circuits.
14.
Output Attenuator (-50dbm)
Makes mixer output mic. level and changes source impedance to 200 ohms
(typical mic. impedance).
15.
Battery Switch (On Off/Charge)
Locking toggle switch. In the ON (up) position switches the mixer on under battery
power, in the OFF/CHARGE position switches mixer off under battery power but
enables Ni-Cad charging circuits (see 16).
16.
IEC Mains Socket/Integral Fuse Holder
Regardless of battery switch position (see 15) application of mains power via this
socket (110v or 240v 60/50 Hz MUST be specified) always powers the mixer. With
reference to 15 above, if ON position selected and mains power is lost the mixer will
fail to battery operation. If OFF/CHARGE position selected the mixer is mains
powered and the Ni-Cads are being charged.
DO NOT OPERATE THE MINX FROM MAINS POWER WITH ORDINARY DRY CELLS AND
OFF/CHARGE POSITION SELECTED.
CANFORD AUDIO PLC
CROWTHER ROAD WASHINGTON
TYNE & WEAR NE38 OBW, UK
admin
(0191)418 1000
sales
(0191)418 1122
fax
(0191)418 1001
technical data
