Warranty Information
LIMITED ONE (1) YEAR WARRANTY ON CANE CREEK eeSilk
eeSilk seatposts are warranted against defects in materials or workmanship for one year from the date of purchase. This warranty applies to the
original owner only. At their discretion, Cane Creek Cycling Components will repair or replace any defective seatpost with the same or comparable
model. This warranty is void if the seatpost is damaged as a result of abuse, alterations, modifications, improper adjustment, lack of maintenance,
crashes, or other conditions judged by Cane Creek Cycling Components to be abnormal, excessive, or improper. It is mandatory that a Return
Authorization Number (RA#) is received (by calling or emailing Cane Creek) before any return is made. Additionally, a dated Proof of Purchase must
accompany the seatpost when returned.
The eeSilk seatpost can be tuned for different rider weights and riding styles by selecting
the elastomer that best fits rider needs and performance preferences. The eeSilk seatpost is
shipped with a #5 elastomer installed. #1, #3, #7, and #9 elastomers are sold separately.
Rider Weight
Elastomer Rating
≤
110lb (
≤
50kg)
1
(Sold Separately Part# BAE0098)
100-160lb (45-73g)
3
(Sold Separately Part# BAE0099)
150-210lb (68-95kg)
5
(Installed on Post)
200-250lb (90-113kg)
7
(Sold Separately Part# BAE0101)
200-250lb (90-113kg)
*Extra Firm
9
(Sold Separately Part# BAE0102)
NOTICE - The eeSilk seatpost must be set-up
with the appropriate elastomer before riding.
See below for elastomer instructions. Maximum
allowable rider weight is 250lb (150kg)
NOTICE - eeSilk seatposts are designed to absorb small bumps only. You should still stand up
when encountering large obstacles on the road or trail.
Selecting Elastomers -
Changing Elastomers -
Maintenance -
1. Using a 4mm hex wrench and a 3mm hex
wrench, loosen the axle on the bottom of the rear
parallelogram arm and remove the 3mm bolt.
2. Install the pin tool provided in the packaging onto
the axle and push the axle out of the axle bore.
3. Lift the arm away from the axle bore on the post
and remove the current elastomer.
4. Insert the new elastomer in the opened arms,
orienting the elastomer into the arm profile.
5. With the new elastomer placed between the two
arms, push the arm down to line up the axle hole
on the post and the axle holes on the arm.
6. Using the pin tool as a guide for the axle to enter
the axle bore, push the axle into the axle bore pin
side first. Remove the pin from the axle once the
axle is fully inserted into the axle bore.
7. Fasten the 3mm hex bolt back into the axle.
Holding the 4mm axle bolt, fasten the 3mm hex
bolt to 2.0 Nm (17.7 in lb)
Occasionally check the torque of the 4mm axle bolt
to make sure the axle nut and axle bolt are not loose.
Additionally, the pivot axles could be periodically
lubricated with a light oil.
*Saddle can remain Installed
4mm Hex
3mm Hex
Hold
Pin Tool
Thread Together
3mm Hex
Torque to 2Nm
4mm Hex
AAE0305