12
3.
Touch START/+30SEC pad to confirm.
NOTE:
During defrosting program, the system will pause to remind you to turn over the food.
P
RESET
Preset function allows the oven to start up in a later time.
1.
Set a cooking program (except quick start, speed defrost and weight defrost).
2.
Touch the PRESET pad once.
3.
Use the
+/-
pads to enter hour digit.
4.
Touch START/+30SEC pad to confirm.
5.
Use the
+/-
pads to enter minute digit.
6.
Touch START/+30SEC pad to confirm.
NOTE:
In preset mode, the preset time can be seen by pressing PRESET pad, if press STOP pad when
the display shows the time, the function can be cancelled.
C
HILD LOCK
Use to prevent unsupervised operation of the oven by little children.
To set the child proof lock: In standby mode, press and hold LOCK button for 3 seconds, then a beep
will sound, the oven will auto enter child lock mode and the lock indicator light will turn on. In the lock
state, all buttons are disabled.
To cancel the child proof lock: Press and hold LOCK button for 3 seconds, then a beep will sound
and the indicator light will come off.
E
CO FUNCTION
Set the method: In standby mode, pressing ECO pad once can turn off the display screen and a beep will
sound. The oven will enter power saving mode.
Lifting method: During the power saving mode, it will be canceled by press any pad and a beep will sound.
The display screen will light up.
M
UTE FUNCTION
To set mute function: Press MUTE pad once, then a beep will sound. This time by all the function keys
have no prompt tone.
To relieve mute function: In mute mode, Press MUTE pad once, then a beep will sound.
A
UTOMATIC PROTECTION MECHANISM
FREQUENCY CONVERSION PROTECTION -
In the microwave mode, if undetectable feedback signal
for five seconds, the system will stop working, and buzzer constantly issued "DE" hint sound and display
"E-1".After troubleshooting, press the STOP button, the system back to normal standby mode.
OVERHEATING PROTECTION -
Digital tube has been shows E01 and had been "DE-DE" alarm when
the system into the super high temperature protection status. The system into normal standby mode
when faults remove and touch STOP pad.
LOW TEMPERATURE PROTECTION -
Digital tube has been shows "E02" and had been "DE-DE" alarm
when the system enters into the low temperature protection status. Until touch STOP pad, the system
enters into normal standby mode .
SENSOR MALFUNCTION PROTECTION -
In case of short circuit, the system enters into malfunction
