The water removed from the laundry during the
drying cycle is collected in a container at the
bottom of the dryer.
When the container is full the
Full
indicator
on the control panel will light, and the container
MUST
be emptied. However, we recommend that
the container is emptied after each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.
To remove the container
1.
Gently pull the bottom of the kickplate so
that it unclips from the dryer. The top
section can then be unhinged allowing the
kickplate to be completely removed.
2.
Pull firmly on the handgrip and slide the
water container out of the dryer.
Support the container with both hands. When
full, the water container will weigh about 4kg.
3.
Open the lid located on the top of the
container and empty the water.
4.
Refit the lid and slide the water container
back into position.
PUSH FIRMLY INTO
PLACE.
5.
Refit the kickplate by engaging the hinges
at the top and 'snapping' the lower clips
into place.
15
Water Container
40006040.qxd 03/07/2009 10:37 Page 15