Candy DUO, Инструкция по использованию и установке

Страница: 8 / 108

08 GB
Opening the door
Grip the handle in the front panel and pull forward. If the machine
comes open while it is working, an electrical safety device
automatically switches everything off. For the machine to work
properly, the door should not be opened while it is in operation.
Closing the door
Place the basket in the dishwasher. Make sure that the spray arm
is free to rotate and is not obstructed by cutlery, crockery or pans.
Close the door, pressing on it to make sure it is firmly shut.
Interrupting a programme
lt is not recommended that the door be opened while a programme
is running, and especially not during the main wash phase and
final drying.
However, the appliance stops automatically when the door is
opened.
When the door is closed again, the programme continues
automatically.
If you wish to change or cancel a programme that is running, carry
out the following procedure:
"PROGRAMME SELECTION" button down for at least
5 seconds. The programme indicator lights will turn on and off
individually and sequentially and some audible signals will sound.
indicator lights will flash.
Before starting a new programme, you should check that there is
still detergent in the dispenser. If necessary, top up the dispenser.
WARNING: if the door is opened during the drying phase, an
intermittent audible signal is activated to advise that the cycle is
not yet completed.
A 5 seconds alarm will sound (if not muted) 3 times at 30 seconds
intervals to signal that the programme has ended.
The selected programme indicator light (2 indicator lights for the
"COLD RINSE" programme) will start to flash.
Dishes can now be removed and the dishwasher turned off by
pressing the
"ON/OFF" button or dishes can be loaded for new
cycle.
The alarm for the programme end may be muted as follows:
IMPORTANT
The dishwasher must ALWAYS be offbefore start of this
procedure.
1. Hold down the "PROGRAMMESELECTION" button and at
the same time switch on the dishwasher by pressing the
"ON/OFF" button (a brief audible signal will sound).
2. Keep the "PROGRAMME SELECTION" button pressed for at
least 15 seconds (during this time, 2 audible signals will sound).
3. Release the button when the second audible signal sounds (3
"PROGRAMME SELECTION" indicator lights will come on).
4. Press the same button again: the 3 indicator lights (which
indicate that the alarm is activated) will start flashing (to indicate
that the alarm is off).
5. Turn off the dishwasher by pressing the "ON/OFF" button to
confirm the new setting.
To turn the alarm on again, follow the same procedure.
WARNING!
If any problem occurs, turn the dishwasher off by
pressing the "ON/OFF" button and start the
procedure again from the beginning.