Candy CHSBSO 6174B, Инструкция по эксплуатации

Страница: 19 / 296

circuit breaker or fuse. Never clean
the appliance with a steam cleaner
Moisture could accumulate in
electrical components, danger of
electrical shock! Hot vapors can lead
to the damage of plastic parts. The
appliance must be dry before it is
placed back into service.
/ŵƉŽƌƚĂŶƚ͊
Ethereal oils and organic solvents can
attack plastic parts, e.g. lemon juice or the juice
form orange peel, butyric acid, cleanser that contain
acetic acid.
x
Do not allow such substances to come into
contact the appliance parts.
x
Do not use any abrasive cleaners
x
Remove the food from the freezer. Store them
in a cool place, well covered.
x
Switch the appliance off and remove the plug
from the mains, or switch off or turn out the
circuit breaker of fuse
x
Clean the appliance and the interior accessories
with a cloth and lukewarm water. After cleaning
wipe with fresh water and rub dry.
x
After everything is dry place appliance back into
service.
Troubleshooting
ĂƵƚŝŽŶ͊
Before troubleshooting,
disconnect the power supply. Only a
qualified electrician of competent
person must do the troubleshooting
that is not in this manual.
/ŵƉŽƌƚĂŶƚ͊ There are some sounds during normal
use (compressor, refrigerant circulation).
If the malfunction shows again, contact the Service
Center
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
WƌŽďůĞŵ WŽƐƐŝďůĞĐĂƵƐĞ ^ŽůƵƚŝŽŶ
Appliance dos not
work
Appliance freezes
or cools loo much
Mains plug is not
plugged in or is
loose
Insert mains plug.
Fuse has blown or
is defective Check fuse,
replace if
necessary.
Socket is
defective Mains
malfunctions are
to be corrected
by an electrician.
WƌŽďůĞŵ WŽƐƐŝďůĞĐĂƵƐĞ ^ŽůƵƚŝŽŶ
Temperature is
set too cold or
the appliance
runs at SUPER
modes, Turn the
temperature
regulator to a
warmer setting
temporarily.
The food is not
frozen enough.
Temperature is
not properly
adjusted. Please look in the
initial
Temperature
Setting section.
Door was open
for an extended
period. Open the door
only as long as
necessary.
A large quantity
of warm food was
placed in the
appliance within
the last 24 hours. Turn the
temperature
regulation to a
colder setting
temporarily.
The appliance is
near a heat
source. Please look in the
installation
location section.
Heavy build up of
frost on the door
seal.
Door seal is not
air light. Carefully warm
the leaking
sections of the
door seal with a
hair dryer (on a
cool setting) At
the same time
shape the
warmed door seal
by hand such
that it sits
correctly.
Unusual noises
Appliance is not
level. Re-adjust the
feet.
The appliance is
touching the wall
or other objects.
Move the
appliance slightly.
A component,
e.g. a pipe on the
rear of the
appliance is
touching another
part of the
appliance or the
wall.
If necessary,
carefully bend
the component
out of the way
Side panels are
hot
It’s normal. Heat
exchange is in the
side panels. Take gloves to
touch side panels
if need.
If the malfunction shows again, contact the Service
Center.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.
1