Wash cycle table
Starting a cycle wash
Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the lower
basket first, then the upper one.
Pour in the detergent
Close the door, press the power button to switch on the machine.
Press the program button, the wash program will be changed as follows direction:
Intensive > Normal > Eco > Glass > Daily > Rapid
If a program is selected, the response light will light. Then press the Start/Pause button, the dishwasher begins to
start.
Change the program
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise the
detergent may have already been released and the appliance may have already drained the wash water. If this is
the case, the detergent dispenser must be refilled.
Open the door, press the program button more than 3 seconds, the machine will be in standby state, then you
can change the program to the desired cycle setting.
If you open the door during a wash cycle, the machine will pause. The program light will stop blinking and the
buzzer will sound every minute unless you close the door. After you close the door, the machine will keep on
working after 1 seconds.
At the end of the wash cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds then stop. Turn off the
appliance using the On/Off button and open the door of the dishwasher. Wait for a few minutes before unloading
the dishwasher to avoid handling the dishes while the are still hot. They will also dry better.
