CanDock G2 JETSLIDE, Инструкция по установке и эксплуатации

Страница: 3 / 18

I) INSTALLATION & USE OF THE
J
ET
SLIDE
1) ASSEMBLY
Advices :
- Assemble on a flat surface rather than water. It will be easier that
way.
- Assemble the cubes around the JetSlide. If you
attach it to a dock, make sure the plugs are facing
the shore. If your JetSlide is an independent unit,
black plugs must be oriented toward the front of
your unit.
Steps : See ANNEXE A
1)
Insert spacers before screwing the connecting pins. When the cubes
are put together, the tabs (
See B ) will nest on top of each other ( See
C ). The tabs are numbered (S ee D ), one (1) being the lowest and four
(4) the highest. The JetSlide’s tabs are placed just below the #1 tab
of the cubes. You must insert spacers at the right positions to
generate the equivalent of four (4) tabs on top of the Jetslide’s tabs
(
See E, F ).
2) Insert spacers as you position cubes around JetSlide.
3) Insert connecting pins around the JetSlide and make a slight hand
tightening, then tighten them with the T key until they are snug (
See
H ).
4)
In position 1 ( See I ) connecting pin require a sliding nut because the
JetSlide has no tab for this position. Place a sliding nut on the lower
tab (1).
5) Install the exterior lug connectors and screw them around the
JetSlide using the proper tool for this purpose (
See G ). You will
never have more than two (2) tabs or more than two (2) spacers to
install.
Normally, in the case of a personal water craft, the cubes are positioned
rearmost of JetSlide are not necessary, but if a higher flotation is required, you
can add cubes or corner cubes (therefore using JetSlide bolts to fix the
modules on the last JetSlide tab. You will also need spacers).