35
•
Press the CLR/TEST key to lock in the
digit’s value. The next digit will begin
to flash.
•
Repeat the above two steps to select
and lock in each of the two remaining
digits.
•
When the last digit has been set, the en-
tire threshold value and unit will flash.
•
Press the CLR/TEST key to return to
the Rate Mode or wait about 10 sec-
onds.
The Source Finder Mode
The Source Finder Mode allows the unit to lo-
cate an isolated source. In this mode, the unit
will start clicking if the unit is near radioac-
tive material. As you move closer to the radio-
activity (or farther away), the unit will click
faster (or slower).
For best results, aim the top of the unit at the
suspected source of the radiation.
The Rate and Dose modes are active when the
Source Finder Mode is enabled. This means
that you can read the higher Rate or Dose
without exiting the Source Finder Mode.
