Canature HT765TO-75, Руководство пользователя

Страница: 6 / 24

6
Where To Install The Filter

Use copper, brass, or PEX pipe and fittings.

Some codes may also allow PVC plastic
pipe.

ALWAYS install the included bypass valve,
or 3 shut-off valves. Bypass valves let you
turn off water to the filter for repairs if
needed, but still have water in the house
pipes.

5/8” OD drain line is needed for the valve
drain. A 10’ length of hose is included.
with some models.

Place the filter tank as close as possible to
the pressure tank (well system) or water
meter (city water).

Place the filter tank as close as possible to
a floor drain, or other acceptable drain
point (laundry tub, sump, standpipe, etc.).

Connect the filter to the main water supply
pipe BEFORE the water heater. DO NOT
RUN HOT WATER THROUGH THE FIL-
TER. Temperature of water passing
through the filter must be less than 100
deg. F.

Do not install the filter in a place where it
could freeze. Damage caused by freez-
ing is not covered by the warranty.

Put the filter in a place water damage is
least likely to occur if a leak develops. The
manufacturer will not repair or pay for wa-
ter damage.

A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6
feet of the softener. The transformer has
an attached 6 foot power cable. Extension
cables are available. Be sure the electric
outlet and transformer are in an in-
side location, to protect from wet
weather.

If installing in an outside location, you
must take the steps necessary to assure
the filter, installation plumbing, wiring,
etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as
when installed indoors.

Keep the filter out of direct sunlight.
The sun’s heat may soften and distort
plastic parts.