Canature WaterGroup Tannins 89 TLC, Руководство пользователя, Страница: 5 / 20

5
•
Place the softener as close as possible to
the pressure tank (well system) or water
meter (city water).
•
Place the softener as close as possible to a
floor drain, or other acceptable drain point
(laundry tub, sump, standpipe, etc.).
•
Connect the softener to the main water
supply pipe BEFORE the water heater.
DO
NOT RUN HOT WATER THROUGH THE
SOFTENER
. Temperature of water pass-
ing through the softener must be less than
100 deg. F.
•
Keep outside faucets on hard water to
save soft water and salt.
•
Do not install the softener in a place where
it could freeze.
Damage caused by
freezing is not covered by the war-
ranty.
•
Put the softener in a place water damage
is least likely to occur if a leak develops.
The manufacturer will not repair or pay for
water damage.
•
A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6
feet of the softener. The transformer has
an attached 6 foot power cable.
Be sure
the electric outlet and transformer
are in an inside location, to protect
from wet weather.
•
If installing in an outside location, you
must take the steps necessary to assure
the softener, installation plumbing, wiring,
etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as
when installed indoors.
•
Keep the softener out of direct
sunlight
. The sun’s heat may soften and
distort plastic parts.
Where To Install The Softener