Using the Raven II CDPD Modem – Canary Systems Application Note #12 – March 2002 – Page 3 of 8
COM/IP Installation and Configuration
MultiLogger cannot communicate directly to the Winsock, or TCP/IP, port of your operating system,
therefore a type of interface software will be required to facilitate communication between MultiLogger
and the Winsock port. This Application Note will provide information to utilize
COM/IP
, from Tactical
Software. This software may be downloaded from a distributors website, go to the following link:
http://www.pcmicro.com/comip/download.html
A 30-day evaluation copy may be downloaded without charge, to purchase the
registration codes will cost $65. Contact Canary Systems for more information on
purchasing this software.
Install COM/IP using the supplied installation file. Leave the registration
information blank to install the 30-day evaluation, fill the fields in if you have
registered your copy.
During installation of COM/IP you will be prompted to select a Port to use as the
interface port for MultiLogger. The dialog will display a list of available ports, to
avoid IRQ conflicts it is recommended to select COM5 (if it’s available), as shown
to the right.
Click
OK
to advance to the next configuration step, installing the “Modem” that
forms the interface to our TCP/IP. Follow the instructions shown on the form, be
sure to select the COM port that was configured previously, in our case
COM5
.