Canaan AvalonMiner1047, Руководство пользователя, Страница: 9 / 13

• After the device is turned on, the indicator light is white for about three
seconds. During this period, press the FUNC button to enter the configuration
mode.
• Under normal mining conditions, the indicator light is green
• The indicator light is yellow during system preparation
• The indicator is when the system is overheated
• When the system is running, press the FMS software or manually press the
FUNC key. The indicator light is always white, press again to restore the
original color.
• Restore factory settings: When power is on (before the indicator flashes ),
press the FUNC function button for five seconds, until the white light flashes
to indicate success, then press RESET or disconnect the power to restart.
Operation mode
The device has two modes of operation: “Normal Mode” and “Configuration Mode”.
Normal mode
In normal working mode, the device runs in this mode for most of the life cycle. In this
mode, the network can use DHCP (dynamic acquisition) or static IP, and the factory
setting is DHCP.
Configuration mode
The device will enter this mode by pressing the FUNC key during the white light
(about three seconds) after startup. In this mode, the IP address is static (address:
192.168.168.168, subnet mask: 255.255.255.0). The built-in Web service of the
device can be accessed through a PC browser to configure information such as the
network, mine pool, and password. Set the PC to a static IP address:
192.168.168.100 (or any other non-conflicting address on the same network
segment), subnet mask: 255.255.255.0, connect to the same network as the device
(under the same switch or router, or PC) Device network cable directly connected)