Canaan AvalonMiner 1066 Pro, Руководство пользователя

Страница: 5 / 19

1066 Pro
4
connection
FUNC
：
Functional button. It can be used to reset the miner back to the factory settings,
enter the configuration mode, and switch lighting status in operation, etc.
Light Indicator
• The light indicator flashes in red several times after power-on
• After device startup, the indicator lamp turns white for about three secs. During this
period, press the FUNC key, then device will enter the configuration mode.
• The indicator lamp is green under normal mining condition.
• The indicator is yellow during system preparation.
• The indicator lamp is red when the system is overheated.
• During system operation, the light indicator turns white by FMS software or
manually pressing the FUNC key, and the lamp reset to original color after the
button pressed again.
Reset Mining to factory settings: Press the FUNC function key (before the red indicator lamp
flashing) when power on for five seconds till the white indicator flickers which means setup
finished, and then press the RESET or power to restart.
Chapter 3 Work Mode
The device has two work modes: “Normal Mode” and “Configuration Mode”.
Normal Mode
The device runs in this mode most of time, in which network can be using DHCP (dynamic
acquisition) or static IP. The default setup is DHCP.
Configuration Mode

Press the FUNC key when the lamp is white (about three secs.) after startup, and the device
will enter configuration mode.

In this mode, the IP address is static (address: 192.168.168.168, subnet mask: 255.255.255.0).
The built-in Web service of the device can be accessed through PC browser to configure
network, mining pool, password and other information.

Set PC to static IP address: 192.168.168.100 (or any other non-conflicting address with the
same segment), subnet mask: 255.255.255.0, connect to the same network with the device
(under the same switch or router, or directly connect PC to the device network).