Can-Am 2010 DPS, Техническое руководство

Страница: 41 / 58

Section 01 TECHNICAL MANUAL
Subsection 02 (AIR CONTROLLED SUSPENSION (ACS))
vmr2010-004-006_a
1. Retaining screws
6. Unscrew air fittings, pneumatic valve and check
valve.
vmr2010-004-007_a
1. Manifold air inlet fitting (from compressor)
2. Auxiliary line check valve
3. Pneumatic valve
4. Shocks fitting
5. Module fitting
ACS Manifold Installation
The installation procedure is the reverse of re-
moval procedure, however pay attention to the
following.
If fitting is the one previously removed (old one),
apply
LOCTITE 592 (PIPE SEALANT) (P/N 293 800 018)
on all male threads.
If fitting is a new one, do not apply sealant, it
should be already applied on male threads.
On pneumatic valve, check valve, and solenoid
valve, apply
LOCTITE 592 (PIPE SEALANT) (P/N 293
800 018)
on all male threads.
Install check valve with arrows pointing toward
manifold.
vmr2010-004-007_b
Install air fittings, pneumatic valve and check valve
as follows.
vmr2010-004-007_a
RETAINING SCREWS ARE OFFSET TOWARD MODULE FITTING
1. Manifold air inlet fitting (from compressor)
2. Auxiliary line check valve
3. Pneumatic valve
4. Shocks fitting
5. Module fitting
Ensure that air hoses are properly inserted into fit-
tings, refer to the following illustrations.
vmo2010-011-102_a
PUSH HOSE UNTIL THE MARK IS COMPLETELY INSERTED
1. Fitting
2. Mark
A. Must be inserted into fitting
vmo2010-011-103
HOSE PROPERLY INSERTED INTO FITTING
34
vmr2010-004