Can-Am 2010 ACS, Техническое руководство

Страница: 13 / 58

Section 01 TECHNICAL MANUAL
Subsection 01 (DYNAMIC POWER STEERING (DPS))
The active DPS mode will be displayed in the
lower portion of multifunction gauge.
vmo2010-004-004_a
1. DPS mode indication
How to Change DPS Assist Mode
To change DPS ASSIST mode, press and hold
the OVERRIDE/DPS button for approximately
4 seconds, the DPS system will toggle to the
other available mode. The newly activated DPS
mode will be briefly displayed in the multifunction
gauge.
NOTE: The DPS mode cannot be changed if
the vehicle is in reverse, of if the ACS mode is
displayed in the multifunction gauge on vehicles
equipped with an Air Controlled Suspension.
SYSTEM DESCRIPTION
(COMPONENTS)
DPS Unit
The DPS unit is a self contained unit that includes
the steering gear, the DPS module, the DPS mo-
tor, and the torque sensor.
vmr2010-003-003
DPS UNIT
The DPS module provides DC power to the mo-
tor. The amount and duration of that DC power is
determined by the inputs to the DPS module. The
direction in which the motor turns is changed by
reversing the polarity of the circuit current.
The DPS motor does not "spin", but rather turns in
very small increments based on the amount, du-
ration, and direction of DC power delivered by the
DPS module.
DPS Unit Protection
To protect the DPS electronic components, the
steering assist behavior will change as follows.
CONDITION DPS BEHAVIOR
When motor internal
temperature reaches a certain
temperature (DPS continuously
estimates it)
DPS internal board temperature
is above 85°C (185°F)
Steering assist
will gradually
decrease.
DPS internal board temperature
is above 100°C (212°F) Steering assist is
stopped.
When the DPS unit temperature is back within
normal operating range:
– Turn the ignition key OFF.
– Wait 30 seconds.
– Turn the ignition key ON.
Steering assist should resume normal operation.
6
vmr2010-003