Remove the holding strap then pull the
battery out of frame.
vmo2006-007-025_a
1. Battery
2. Holding strap
Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.
Fuses
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective fuse.
If a fuse is damaged, replace it by one
of the same rating.
CAUTION:
Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located in the front service
compartment and at the rear near bat-
tery.
vmo2006-007-012_a
FRONT — FUSES LOCATION
1. (F1) Ignition coils (5 A)
2. (F2) Fan (20 A)
3. (F3) Fuel injectors (5 A)
4. (F4) Speedometer/speed sensor/tail
lamp (7.5 A)
5. (F5) Fuel pump (7.5 A)
6. (F6) Engine Control Module (ECM) (5 A)
7. (F7) Accessories (20 A)
vmo2006-007-031_a
REAR — FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
118
_____________________
Содержание 2007 Outlander 500 EFI
