CAMSO ATV R4S, Руководство пользователя

Страница: 26 / 50

23
MAINTENANCE
200 mm Wheels
Verify wear on contact band ( 1 ) of 200-mm
Wheels. The wheel must be replaced if the
surface is worn out, cracked or has holes in it. A
wheel that is excessively worn will not offer
enough support for track guidance. Track guides
may also wear prematurely. Figure 40.
Figure 40
Track Guide
Verify wear on Track Guide by measuring width
of guide rails. If rail dimensions, illustrated in
Figure 41, are less than 5 mm, at any point along
the Track Guide, replace part. If guide rails are
worn to the point that the concave shape is no
longer visible, replace part. Figure 41.
Figure 41
CAUTION: An overly worn Track Guide could
cause premature wear on other guidance
components of the system.
Sprocket
Check wear on Sprocket by measuring sprocket
teeth as illustrated on Figure 42. Replace
sprocket if dimensions are less than 19 mm.
CAUTION: Excessive wear could lower track drive
efficiency and reduce System performance.
Figure 42
CAUTION: In order that wear on sprockets be
produced evenly across all 4 sprockets, the vehicle
should be driven in 4x4 mode, especially in
abrasive conditions.
Skates
Verify wear of exposed part of skates. Replace
skates if exposed part is less than 25.7 mm high -
- (30.7 mm when new). Verify also width of
skates. If skates are less than 9 mm wide -- (13
mm when new), replace them. An excessively
worn skate will not offer enough support for track
guidance. Figure 43.
Figure 43