2. Connect IP cameras with PoE48V (PoE 802.3af).
3. Connecting a wireless IP system or other device powered PoE24V.
PoE IN 48V connector uses only PoE power lines and does not transmit
Ethernet LAN signal lines.
4. Power sources
QUICK START
www.camsat.com
Full user's manual available at www.camsat.com
2
Full user's manual available at www.camsat.com
3
The camera must be connected to the
RJ45
socket labeled
LAN / PoE OUT 48V
via LAN cable with
RJ45
connectors on both sides. Connector
LAN / PoE OUT 48V
supplies 48V power and also transmits
the signal lines in a standard
LAN 10BASE-T, 100BASE-TX
directly (1: 1 / non-interlaced) to connec-
tor
LAN / PoE OUT 24V
.
The wireless IP system must be connected to the RJ45 socket labeled LAN / PoE OUT 24V via LAN
cable with RJ45 connectors on both sides. Connector LAN / 24V PoE OUT supplies 24V power and also
provides the signal lines in a standard LAN 10BASE-T, 100BASE-TX directly (1: 1 / non-interlaced) to
connector LAN / PoE OUT 48V. It connects Ethernet LAN signal from IP cameras with radio IP module.
b) Universal power supply must be connected to the screw socket l 48V / GND. You must
always remember to maintain the correct polarity (+ -). Power supply Plus to the terminal
48V, power supply Minus to the terminal marked GND.
a) The power supply or the PoE48V Switch in standard PoE 802.3af must be connected to the RJ45
socket labeled 48V PoE IN.
!
It is unacceptable to use two power supplies at the same time.
!
The power supplied may not be less than the total maximum power consumption
of powered devices (IP wireless system).
After connecting the power supply two LEDs will light up indicating the voltage appears on the
corresponding LAN ports:
Red LED 48V
means the appearance of voltage (PoE) on the connector LAN / PoE OUT 48V
Green LED
indicates the appearance of voltage (PoE) on the connector
for LAN / PoE OUT 24V / 1A
!
P
o
ER-24h
