Assembly
Place mounting brackets designed for mounting on a steel beam or rail in the appropriate
holes in the rear of the device and tighten securely. Attach the device to the construction with
the antenna pointed directly at the point of receiving.
We use the U-Bolt handle which is included.
WARNING
The antenna of the transmitter must "see” optically with an antenna at receiving
part of the set in the same polarity. Do not install the equipment rotated 90
degrees relative to each other as this will result in incompatibility of polarized
antennas.
Do not install the devices at distances of less than 0.5 m from each other. It is
recommended to use a minimum distance of 1m.
Install receiver and antenna directed exactly to the transmitting point. Set the desired
operating channel according to the table. Channel numbers and polarity of antennas should
be the same in both cooperating transceivers. Connect the power cables together with power.
The device must be powered from the supplied AC adapter PoE48V.
For installation you can use our accessories:
A) MTS-1D – Wall/roof mounting
B) MT-2D - Mounting to the pipe
