2. R&TTE declaration of conformity
This device meets requirements of the European directive on radio equipment, telecommu-
nication terminals as well as on their mutual identification and compatibility (Directive
1999/5/CE of the European Parliament and the Council of Europe, march 1999, on radio
equipment and telecommunication terminal equipment and the mutual recognition of their
conformity).
CAM-Analog2.0 is compliant with provisions related to the safety in using electrical de-
vices. Observe the following guidelines:
•
the power outlet must be grounded in compliance with applicable provisions,
•
before transferring the device or performing any other technical operations, discon-
nect the power supply,
•
do not use any damaged or worn power supply cables, as the pose a threat to the
user’s safety,
•
installation works must be performed by sufficiently qualified technicians,
•
do not use the device on locations where flammable substances are kept,
•
secure the device so that children or unauthorized persons should not have access to
it, make certain that the device has been reliably mounted,
•
the device is off only after disconnecting its power supply cables and the cables be-
tween it and other devices,
•
if the device is transferred to a room where the temperature is higher than where it
has been previously kept, water vapour may condensate inside its casing which will
prevent its proper use (wait until the condensed water evaporates).
Distances and interferences
1.
The transmission distance may vary, depending on the frequency,
environment, radio waves, buildings, weather conditions, etc.
2.
When the transmitter is near such equipment as the TV set, R-LAN
wireless network, another transmitter, or when it is placed between
other radio devices, then the video stream may be interrupted or the
devices might even lose the connection. If this occurs, increase the
distance between the interrupted devices and the transmitter.
3.
The signal reception may vary, depending on the transmitter’s
working height and angle. If the signal reception is not stable,
optimise the antenna settings.
4.
Meteorological radars operating withing the frequency ranges of
5.250-5.350MHz and 5.650-5.850MHz have the highest priority.
These radars can interrupt the device operation or prevent it entirely.
Warning
The antennas used for transmission from this transmitter must be installed
according to the instruction manual and they must be placed at least 30cm
from all persons. The transmitter is not compatible with another antenna
nor transmitter.
CAM-Analog2.0 Instrukcja
4
