Campomatic WM111XL, Инструкция по эксплуатации

Страница: 3 / 13

2
SM2842
PREWASH:
USING THE WASHING MACHINE
OPTIONAL FUNCTIONS
GB
SPIN LOAD IMBALANCE CONTROL:
This washing machine is equipped with a special electronic control system for correctly
balancing the wash load. Prior to each spin, the system ensures that the washing is evenly
distributed in the drum. If the washing is not evenly distributed, the final spin speed is
reduced, and if the load is very unbalanced, the spin is not effected.
If one of the following buttons is selected, the corresponding LED will switch on. But if it has been
selected by mistake or you have changed your mind, simply press it again to cancel the selection.
VARIABLE SPIN:
The machine offers a wide selection of spin speeds that can be selected beforehand according to the
wash programme. To change the spin speed, simply press button (H) to select the required speed. The
corresponding speed led will light-up each time the button is pressed. To exclude the spin, select the led
corresponding to symbol , if present, or the writing “no-spin”.
NB. the maximum spin speed will vary according to the model and is indicated by the Leds on the machine.
The maximum spin speed that can be selected for each programme is indicated by the leds that light-up
automatically when the wash programme is selected.
DELAYED START:
The machine is fitted with a delayed start function. This allows the washing machine to be programmed
to start the wash cycle up to 8 hours later. The delay in hours can be selected as follows: press the but-
ton to set a delay of 1, 2, 4, 8 hours. When the START button (L) is pressed, the selected led will flash
or button (I) will light up (according to the model), signalling that the function has been activated. The
machine will wait for the number of hours set to elapse and then start the wash cycle automatically.
START BUTTON:
After having carried out all the operations described in points 1 to 8 in the paragraph “ WASHING
CYCLE
” press this button and the washing machine will begin its washing cycle. The relative
LED
will light up after 2-3 seconds, to indicate that the door is locked and the program has started.
PROGRAMMER KNOB “STOP”:
The stop function resets the washing machine. If, for any reason, you want to change the wash pro-
gramme or add more washing to the load during the wash cycle, simply place the programmer knob
in position “STOP”, then re-position the knob on the new programme and press the “ START ” button.
Warning!! only use this function if strictly necessary and then only if the programme
to reset has been running for a few minutes. Before opening the door after a reset,
wait 2 minutes for the locking mechanism to release.
Press this button to run a short wash at a maximum temperature of 40°C of approximate duration
10 minutes. This function can only be used with the “ COTTON ” and “ SYNTHETIC ” programmes
and
DAILY
”
STRONG WASH:
N.B. When using this function, remember to put some detergent in the pre-
wash compartment too.
Press the button and the machine will carry out a wash cycle at the set temperature but lasting
longer.
The button is active with “
COTTON ” and “ SYNTHETICS ” programs.
I
L
STOP