Campomatic WD13TX, Руководство пользователя

Страница: 28 / 36

EN - 25
accumulated residue.
To remove the detergent drawer:
• Pull the drawer forwards until it is fully
extended.
• Gently press down on the detergent
drawer (as shown above) and pull the
drawer from its housing.
• Clean the drawer with water and a soft
brush.
• If there is any residue in the drawer
housing, remove with a soft brush.
Take care to prevent any residue from
dropping into the machine.
• Dry the drawer thoroughly and slide it
back into the housing.
Do not wash your detergent drawer
in dishwasher.
Fluid detergent level plate (*)
Remove the fluid detergent level plate for
cleaning and maintenance purposes, as
shown and wash off any detergent residue.
Slide the fluid detergent level plate back
into the guides. Make sure that there is no
remaining detergent residue.
(*) Specifications may vary depending on
the product purchased.
9.4. Pump Filter
1
3
5
7
2
4
6
8
The pump filter system in your Washer
Dryer prolongs the life of the pump by
preventing lint from entering your machine.
We recommend that you clean the pump
filter every 2 months.
The pump filter is located behind the cover
on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder spade
(*) supplied with your machine or liquid
detergent level plate to open the pump
cover.
2. Lodge the end of the powder spade
or liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
3.
Pull the black rubber hose forward
and detach it from its clamp, place a
container under it and remove the plug
from the hose.
4. Collect the water drained from your
machine in a container.
NOTE:
Depending on the amount
of water inside the machine, you may have
to empty the water collection container a
few times.
• Once the water has fully drained, fit the
plug back on the hose.
• Fit the hose back into the clamp.
5.
Loosen the filter cover by turning it
anticlockwise and remove by pulling.
6. Remove any foreign materials from the
filter with a soft brush.
7. After cleaning the filter replace the filter
cover and tighten by turning clockwise.
• Please note that the filter cover may
leak water unless re-fitted properly.
8. Close the filter cover.
• When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel of the
machine.