CMX-3G-4SDI Set Up Instructions
1. Secure the units in a safe loca on, where they will not be subject to impact and where there is
room around the unit so nothing will interfere with the
fi
ber op c cabling causing it to bend sharply
in a ght radius in any way which can severely a
ff
ect the signal transfer.
2. Carefully connect your source(s) to the transmi er input(s) and the receiver unit output(s) to your
receiving device input(s) using the BNC connectors on the transmi er and on the receiver unit.
3. CLEAN*
the
ST
fi
ber op cal cable contacts that will be used for connec ng the Tx and Rx units and
a ach the
fi
ber cable to the ST connec ons and secure, as you would secure a bayonet BNC. While
pressing lightly in on the connector, twist it in a clockwise direc on about 1/8 to 1/4 of a turn and
then release. The connector should stay inserted and have backwards spring pressure holding the
bayonet in place.
4. Connect the included power supplies to the transmi er & receiver units, and plug them both into
an AC power source.
* CLEAN: All
fi
ber op cal cable contacts (the end that is inserted and makes contact to enable light
wave transmission through the
fi
ber) require cleaning each me before inser ng into a device’s out
‐
puts or inputs. Failure to clean the contacts can damage the unit’s op cs over me and also render the
cable and the device nonopera onal.
Use cleaning kits designed speci
fi
cally for
fi
ber op cs. Other cleaners may add contaminants not seen
by the naked eye which could damage cables and/or equipment.
Camplex CMX
‐
3G
‐
4SDI
Page 5
