Campingaz CAMP'BISTRO 2, Инструкция по эксплуатации

Страница: 5 / 7

5
equipment, etc.) at a good distance from
other people and flammable material.
As CAmpiNgAz® Cp250/ Cp250 sp
CARTRiDgEs hAvE vAlvEs, EvEN if ThEy
ARE NoT EmpTy, ThEy mAy bE REmovED
fRom This sTovE To mAkE iT EAsiER
To TRANspoRT, AND ThEy mAy bE
fiTTED To oThER EQUipmENT fRom ThE
CAmpiNgAz® Cp250/ Cp250 sp RANgE
WhiCh ARE DEsigNED To opERATE
ExClUsivEly WiTh ThEsE CARTRiDgEs.
- open the cartridge cover (3) (fig. 2).
- Check that the ignition button (1) is set to
position “ ” by turning it clockwise and that
the lever (2) is set to UNloCk.(fig. 3).
Comment: the gas cartridge can only be
locked if the ignition button is in position “
” and the pan support is in place.
- Check that the seal between the stove
and the gas container is in place and in
good condition before connecting the gas
container (see figure 4).
Do not use this
stove if the seal is missing or damaged.
Return it to your dealer.
- install the cartridge in its housing, slot “f”
facing upwards, and engage the cartridge
guide “g” firmly into the slot (fig. 5).
- lock the cartridge by moving the lever (2) to
the loCk position (fig. 6). Close the cartridge
compartment cover (3).
The stove is ready for use.
CAUTION: make sure the cartridge slot “f” is
pointing upward and inserted in the cartridge
guide “g”.
incorrect positioning of the gas cartridge (8) will
cause the regulator to break and/or gas leakage,
producing a hissing sound and gas smell.
in case of leakage (gas smell before opening
the valve), put immediately the stove outside,
in a well-ventilated area, without inflammation
source, where it will be possible to locate and
stop the lead. if you wish to check the tightness
of the stove, do it outside. Do not try to locate a
leak with a flame, use gas leak detection liquid.
C - USE
Additional instructions:
Do not use your stove at a distance closer
than 20 cm to a wall or any other object,
nor closer than 1 meter to a ceiling.
WARNING: Accessible parts may be very
hot. Keep young children away.
Never touch the pan support (4) or the
burner (5) during or just after using the
stove.
Do not obstruct the ventilation hole (7) in
the cartridge compartment cover (3).
Position the stove on a stable, horizontal
surface and do not move when in use.
Wait until the stove has completely cooled
down before handling and putting it away.
Lighting the burner
The stove is fitted with a piezo-electric lighter
connected to an ignition electrode (6).
- Turn the control knob (1) anti-clockwise until
you hear a click ( ) indicating a spark (fig.
7). if the stove does not light, turn the control
knob to position
“ ” (fig. 9) and start the operation again.
- if the stove still does not light after three
attempts, turn the control knob to position
“ ” and check that the cartridge contains
gas (sound of liquid sloshing when shaken)
before starting the previous steps again. (if
the cartridge is empty, refer to section D -
Changing the cartridge).
Cooking
position the pan on the arms centred over
the burner and adjust the gas flow so that the
flames do not burn higher than the pan.
The size of the flame can be regulated by
turning the ignition knob (2) between the full
flow position (
MAX
) and medium flow position
(
MIN
).
Extinguishing
Turn the ignition knob (1) clockwise to “ ”
position (fig. 9).