Campersat AutoSeek Autoskew
5
H4441 Build 4441 August 2008
It holds the remote receiver and a channel number display as well as 2 buttons for local
operation. Its location should be visible from the owner’s normal seating position, to
ensure proper operation of the remote unit. The remote operates by infrared light (IR).
2d. Free space required by TopBox
Make sure, that there is enough space for the AutoSkew when folded down and when
operating (while the dish is being rotated). You have to fit the system with the LNB
pointing to the back of the vehicle.
This diagram shows you the space required for fitting. With the dish in folded-down
position there is a free space of about 135mm (5 inches) between the dish and the roof.
So you can place the dish over any existing railing, if it is lower than mentioned.
3. Fitting the mounting plate
When you are absolutely sure about the fitting position of the Oyster you should
double check its fitting direction. The LNB arm has to point to the vehicle’s back. The
bolts on the mounting plate are NOT fully symmetrical. This is why you need to
takespecial care to fit the plate into the correct direction. The side with the bolts
closer to each other is the forward direction. You can put the TopBox onto the plate
to see if it fits!
Attention!
Before fixing the mounting plate onto the roof, be absolutely sure to fit it the correct
way. Reversed fittings can damage the antenna while travelling and such events will
not be covered by warranty.
If not done already, remove the 4 nuts fixing the TopBox onto the mounting plate.
Take away the TopBox for the moment. The mounting plate is glued onto the roof
first and fixed with 6 screws afterwards. Before applying the glue, clean the roof and
the plate with cleaning liquid. When done, apply glue onto the bottom side of the
mounting plate. Put the plate onto the position that you decided on before. Again
