weather station data. For more information, refer to
WEATHERPAK M USB connection and
Error
messages
while
running
the
plume
model
are
from
the
plume
mode
l
ling
software.
If
an
error
message
occurs:
l
Consult the
CAMEO
/
ALOHA
web site:
.
l
Contact Campbell Scientific. Although not certified
CAMEO
/
ALOHA
trainers or
representatives, we may be able to help.
5.3 Replacing tripod batteries and fuse
WARNING:
Do not leave batteries in tripod when storing or shipping tripod assembly. Batteries may leak,
causing damage to upper tripod section.
5.3.1 Tripod batteries
The WEATHERPAK M uses ten alkaline D-cell batteries, located in the upper vertical section of the
tripod. Rechargeable and bargain batteries do not perform well in the WEATHERPAK M. Always
use high-quality alkaline batteries. (See
FIGURE 5-1. Battery replacement
Remove the battery plug using a large screwdriver. Insert the blade of the screwdriver into the
slotted plug, gently push the spring-loaded plug, then rotate the plug one-quarter turn either
direction. The plug and spring will come out followed by the batteries. Insert the new batteries by
tilting the tripod section at an angle of approximately 45 degrees. A steeper angle will cause the
batteries to impact the top terminal too forcefully, denting the positive terminal of the batteries.
This may cause the batteries to leak or create a faulty electrical connection. Slide the batteries in,
positive end first, then replace the spring-loaded plug using the reverse procedure.
WEATHERPAK M
31
