Campbell TempVue 10, Руководство по эксплуатации продукта

Страница: 6 / 31

l
Figure 3-2 (p. 4) shows the TempVue 10 and shield extender in the shipping box.
Figure 3-2. Box containing the TempVue 10 and shield extender.
l
Refer to Installation in a radiation shield (p. 15) for instructions about attaching the extender
tube to the TempVue 10 for use in longer radiation shields.
l
Accessories and replacement parts are listed on the web site product page (see
https://www.campbellsci.com/tempvue10 ).
4. QuickStart
A video that describes data logger programming using Short Cut is available at:
www.campbellsci.com/videos/cr1000x-data logger-getting-started-program-part-3 . Short
Cut is an easy way to program your data logger to measure the sensor and assign data logger
wiring terminals. Short Cut is available as a download on www.campbellsci.com . It is included
in installations of LoggerNet , RTDAQ , and PC400 .
The following procedure shows using Short Cut to program the TempVue 10.
1. Open Short Cut and click Create New Program.
2. Double-click the data logger model.
3. In the Available Sensors and Devices box, type TempVue 10. You can also locate the sensor
in the Sensors > Temperature folder. Double click the sensor model. Type the DUT offset
values provided in the calibration certificate that was shipped with the sensor. The
temperature defaults to degree C. This can be changed by clicking the Temperature box
TempVue 10 PT-100 Class A, Precision Air Temperature Sensor
4