3.6 Installation of CH201 regulator
DANGER:
For safety reasons, completely cover the solar panel to limit output current and voltage. If
nothing is available to cover the panel, be careful not to short solar panel (+) and (–) wires
together.
1. Using the supplied mounting hardware, install the CH201 on the mounting plate of an
environmental enclosure (see
(p. 22)). Verify the On/Off switch is in the ‘Off’
position.
2. Plug the end of the wire that ships with the battery with the two-pin connector into the
BAT terminal on the CH201 (the wire is an optional accessory for the BP84). Attach the red
wire to the positive (+) terminal on the battery. Attach the black wire to the negative (–)
terminal on the battery.
The LED on the regulator labeled CHG should not be lit.
FIGURE 3-20. CH201 wire connections
SP50-L, SP90-L, and SP305-L Solar Panels
21
