FIGURE 7-2. Back of SN500SS with the mounting rod and cable connected
2. Attach the mounting bracket to the vertical mounting pipe, or CM200-series crossarm
using the provided U-bolt (
(p. 8)). If mounted to a vertical pipe, ensure that the
pipe does not cast a reflection on the sensor. This includes both the incoming and out-
going sections of the sensor.
FIGURE 7-3. Two views of the SN500SS mounted to a horizontal crossarm
3. Insert the sensor support arm into the mounting block of the mounting bracket kit (
(p. 8)). Make sure the sensor points in the direction of the arrows that appear after the
SN500SS Net Radiometer
8
