Use the following settings:
Setting
RS-232/422/485 interface (default) USB service port
RS-232
Baud rate
115200
115200
Data bits
8
8
Parity
none
none
Stop bits
1
1
Flow control
none
none
The baud rate of the SkyVUE 8M must match the port setting baud rate in the terminal emulator.
The SkyVUE 8M should now be ready to accept commands.
NOTE:
Commands will always output all parameters on a new line after a CR LF (carriage return and
line feed) and then the SkyVUE 8M prompt CS136>. If you only want to see parameter values
without changing them, then enter the command without parameters. If a particular
parameter did not need changing, then the parameter can be replaced with a comma (,).
Back space will abort the command.
5.1.3 Terminal mode command examples
How to enter a command
Example 1
The following text shows an example of setting up the SkyVUE 8M serial port. This example sets
the serial port to RS-232 hand shaking at 115200 bps, 8 data bits, no parity.
serial 0 10 0
To change only the data baud rate, you can replace mode parameter, with a comma (,) as shown
below.
serial , 10
Alternatively if you just wished to change the parity to 8-bits no parity, then type the following:
serial , , 0
You do not need to replace the remaining parameters with a comma (,); you only need to replace
the ones up to the parameter you wish to edit.
SkyVUE™8M Tactical LIDAR Ceilometer
26
Содержание SkyVUE 8M
Страница 1: ...Revision 11 2020 Copyright 2020 Campbell Scientific Inc ...
Страница 105: ...SkyVUE 8M Tactical LIDAR Ceilometer 100 ...