Campbell SkyVUE 8, Руководство по эксплуатации продукта

Страница: 28 / 116

4.3 Mounting the SkyVUE 8
Mount the SkyVUE 8 by bolting to a firm, level foundation. When bolting down, ensure the
SkyVUE 8 can tilt in all desired directions.
FIGURE 4-1 (p. 16) shows the mounting footprint. If a
suitable surface does not already exist, construct a concrete foundation, at least 600 mm (23.6 in)
square and 600 mm (23.6 in) deep, by using the following procedure:
1. Drill four 12 mm (0.47 in) diameter holes using the mount base as a template (see FIGURE
4-1 (p. 16)) to a depth of 77 mm (3.03 in).
2. Clean the holes of all debris.
3. Place washers and nuts on the ends of the wedge anchors supplied (to protect the threads
during installation).
4. Hammer the wedge anchors into the holes until the start of the threads are below the
surface.
5. Tighten the nuts until about 25 mm (0.98 in) of thread protrudes above the surface.
6. Remove the washers and nuts from the protruding length screw, then lower the SkyVUE 8
into place.
7. Secure the SkyVUE 8 with the washers and nuts.
8. If the surface is not level and flat, add washers under the base on one or more of the
foundation screws.
FIGURE 4-1. Mounting base footprint
SkyVUE™8 (CS136) LIDAR Ceilometer 16