Campbell ET107, Руководство по эксплуатации продукта

Страница: 63 / 106

ET107 Weather Station
54
5.9 Battery Installation
FIGURE 5-45. PS150 with lid open
1. Move the PS150 power switch to the OFF position (FIGURE 5-45 ).
2. Remove the cover from the PS150 by sliding the latch up at one end of the
cover and sliding the cover down and out (FIGURE 5-45 ).
3. Install the battery according to the diagram (FIGURE 5-45 ).
4. Plug the battery wire into the connector.
5. Put the cover back on the PS150 and latch it in place.
Do not switch the power supply ON until ac or solar power has
been connected to the back of the enclosure.
The green charge light on the PS150 will flash when charging voltage is
present. The charge light is not affected by the switch. Switching on the power
supply without a charging voltage will run the battery down.
FIGURE 5-46 shows factory wiring between the PS150 and the enclosure.
NOTE
Power Switch
Battery installation diagram