ET107 Weather Station
39
1.
Remove the sensor cable cover off of the back of the enclosure by
loosening the thumb screw at the bottom of the cover and swinging the
cover back and down. The top of the cover has a tab that fits in to the
rectangular hole on the back of the sensor crossarm.
2.
Remove the cap off of the BNC bulkhead connector located on the lower
left corner of the enclosure back.
3.
Attach the antenna cable to the BNC connector.
4.
Gently bring the cable up alongside the pole and loosely wire tie it to the
wire tie block at the top of the enclosure (FIGURE
).
FIGURE 5-29. Loosely wire tie antenna cable
5.
Drape the antenna cable between the pole and the enclosure ( FIGURE
).
FIGURE 5-30. Loosely drape antenna cable over back of enclosure
