Campbell ET107, Руководство по эксплуатации продукта

Страница: 23 / 106

ET107 Weather Station
14
6. Tighten the set screw (FIGURE 5-6 ).
7. Loosen the ground rod clamp. Insert the 4 AWG wire. Tighten the clamp
(FIGURE 5-6 ).
FIGURE 5-6. Close-up of ground rod and 4 AWG cable
5.4 Enclosure
The weather station datalogger, power supply, sensor connection panel,
communications devices, and data retrieval peripherals are mounted in the
ET107 enclosure.
5.4.1 Enclosure Installation
Mount the enclosure on the pole as shown in FIGURE 5-7 .
1. Remove the front lid.
2. Remove the connector cover from the back of the enclosure by loosening
the Phillips screw at the bottom of the cover.
3. Loosen the mounting bracket bolts on the back of the enclosure wide
enough to slide over the pole. Slide the enclosure over the pole.
4 AWG Wire
Ground Rod